We are talking about the “Laser Analog” option, where we choose out of two 0-10V analog outputs. If it is Hypertherm use FineCut consumables for all holes on material thicknesses under 3/16', 40 Amp shielded consumables for thicknesses above 3/16' to 3/8. This will reduce cut speeds but will give you better results. These macros are triggered automatically from a gcode, so apart from adding them to the scripts folder of your profile, you don’t need to do anything else.Īs already mentioned, the laser is controlled by an analog 0-10V signal, which requires the analog output number to be configured in the simCNC settings, “Special I / O” tab. last, but not e the lowest powered consumable set recomended for your material thickness for best hole quality. Together with the postprocessor, you get two scripts, which you need to add to simCNC so it can activate the analog laser control mode. This is a Fanuc postprocessor for Fusion 360 software adapted to simCNC. Postprocessor for FUSION 360 adapted to simCNC software This is the only parameter that needs to be set in the SHEETCAM TNG software settings.Ģ.

It means that the postprocessor generates a gcode in which all cutting parameters are omitted except for the ‘Rapid clearance’ parameter. This solution saves time because an operator does not need to use the SHEETCAM TNG software when changing the cutting parameters.

through cutting parameters table available in simCNC software.

Here is a code example: tWidthPercentage(100) Spacing Before and After Table.

This sets the width of the table as a percentage of the width of the page. manual change of parameters from simCNC screen for plasma cutters. You can set the table width using the setWidthPercentage() metod.The postprocessor has been prepared so that the parameterization of the cutting process is done at the cutting place, i.e., from the level of simCNC control software. We have prepared a dedicated postprocessor for the SHEETCAM TNG software for those using simCNC control software in their plasma cutters. SimCNC plasma SheetCam TNG postprocessor – only one parameter

Setting table position in sheetcam